Options are settings that change shell and/or script behavior.
The set command enables options within a script. At the point in the script where you want the options to take effect, use set -o option-name or, in short form, set -option-abbrev. These two forms are equivalent.
1 #!/bin/bash 2 3 set -o verbose 4 # Echoes all commands before executing. 5
1 #!/bin/bash 2 3 set -v 4 # Exact same effect as above. 5
To disable an option within a script, use set +o option-name or set +option-abbrev.
1 #!/bin/bash 2 3 set -o verbose 4 # Command echoing on. 5 command 6 ... 7 command 8 9 set +o verbose 10 # Command echoing off. 11 command 12 # Not echoed. 13 14 15 set -v 16 # Command echoing on. 17 command 18 ... 19 command 20 21 set +v 22 # Command echoing off. 23 command 24 25 exit 0 26
An alternate method of enabling options in a script is to specify them immediately following the #! script header.
1 #!/bin/bash -x 2 # 3 # Body of script follows. 4
It is also possible to enable script options from the command line. Some options that will not work with set are available this way. Among these are -i, force script to run interactive.
bash -v script-name
bash -o verbose script-name
The following is a listing of some useful options. They may be specified in either abbreviated form (preceded by a single dash) or by complete name (preceded by a double dash or by -o).
Table 31-1. Bash options
|-C||noclobber||Prevent overwriting of files by redirection (may be overridden by >|)|
|-D||(none)||List double-quoted strings prefixed by $, but do not execute commands in script|
|-a||allexport||Export all defined variables|
|-b||notify||Notify when jobs running in background terminate (not of much use in a script)|
|-c ...||(none)||Read commands from ...|
|-f||noglob||Filename expansion (globbing) disabled|
|-i||interactive||Script runs in interactive mode|
|-p||privileged||Script runs as "suid" (caution!)|
|-r||restricted||Script runs in restricted mode (see Chapter 21).|
|-u||nounset||Attempt to use undefined variable outputs error message, and forces an exit|
|-v||verbose||Print each command to stdout before executing it|
|-x||xtrace||Similar to -v, but expands commands|
|-e||errexit||Abort script at first error (when a command exits with non-zero status)|
|-n||noexec||Read commands in script, but do not execute them (syntax check)|
|-s||stdin||Read commands from stdin|
|-t||(none)||Exit after first command|
|-||(none)||End of options flag. All other arguments are positional parameters.|
|--||(none)||Unset positional parameters. If arguments given (-- arg1 arg2), positional parameters set to arguments.|